27
1.
Position the saw guide (24, FIG. 1) to 45° and tighten down the two locking levers (25, FIG.
1 and FIG. 8).
2.
Adjust the incline relative to the saw table at 0°.
3.
Tighten down and lock using the incline adjustment handle (16, FIG. 2).
4.
Loosen the hollow hex head screws located on the splitter blade (13, FIG. 1).
5.
Take the splitter blade out completely and tighten down both screws. Work only with the
splitter blade correctly adjusted.
6.
To do this, completely lower the saw head and turn the lock handle (20, FIG. 9) slightly to
the left. The handle will sink down and you should feel when it is locked.
CAUTION: RISK OF CRUSHING!
A risk of crushing exists when pivoting the saw table!
-
Do not place your hands between the saw table and lateral parts.
-
When pivoting, always keep the table so that it cannot pivot by itself.
-
Ensure that the saw is properly secured to prevent any involuntary pull-back.
7.
Lift the unlocking lever (7, FIG. 1) located on the right side of the saw and carefully pivot
the saw table in a counterclockwise direction.
8.
Once the saw table is properly set in the circular saw, remove the protective cover (28, FIG.
7) of the saw by loosening the hand lever (B, FIG. 7).
9.
Then, lift up the saw blade all the way using the removable cut height adjustment handle
(12, FIG. 2). Attach the saw blade’s protection (14, FIG. 2) to the splitting machine (13,
FIG. 1) and tighten down this protection using the butterfly nut provided.
10.
Connect the dust extraction nozzle (2, FIG. 1) to an appropriate vacuum cleaning system.
11.
Position the parallel guide (15, FIG. 2) in the groove located on the front side of the machine
or in the lateral grooves of the saw table.
ON/OFF switch
To start up the saw, lift the protective cover on the on/off switch (11, FIG. 2) and press the green
switch (see FIG. 10). To stop the saw, press the red switch (FIG. 10).
Adjusting cut height
Turn the cut-height adjustment handle (12, FIG. 2) to the left to decrease the height of the cut.
Turn the cut-height adjustment handle (12, FIG. 2) to the right to increase the height of the cut.
90° cuts
Adjust the cut depth using the adjustment handle (12, FIG. 2).
Withdraw the blade protector (14, FIG. 2).
Loosen the hollow hex-head screws of the splitting blade (13, FIG. 1) and push the splitting blade
downwards until the upper edge of the splitting blade is located 2 mm below the point of the saw
tooth. Take care to keep a distance of 3 to 5 mm between the splitter blade and the saw blade (see
FIG. 11).
Re-set the splitting blade.
During the sawing process, press the saw head onto the part being worked, taking care that the mo-
tor rotation speed does not slow down too much. Saw the part in a single operation.
Inclined cuts from 0° to 45°
After loosening the incline handle (16, FIG. 2), you may pivot the saw blade to the left to the de-
sired angle of 90°-45°.
Take care that the splitter blade is always in alignment relative to the saw blade. Tighten down and
lock using the incline adjustment handle (16, FIG. 2).
Cross-cuts
Adjust the guide (15, FIG. 2) according to the desired angle.
