With the cat back exhaust system properly secure, install a
hanger lock collar on each of the hangers located at the rear
of the car, at the arrow in
Figure 9
. Snug the lock collar
against the rubber grommet and tighten with the enclosed
Allen wrench.
The hanger lock collar prevents the exhaust from sliding
laterally under usage, keeping the tips properly aligned in
the valence openings.
Instructions for the AWE Tuning SwitchPath™ Edition
exhaust installation continue in
Step 10
.
AWE Tuning Touring Edition installation is complete.
Enjoy!
Remove the smaller cap on the posi
-
tap connector and
insert over the red wire on the SwtichPath™ Controller
harness. Insert the wire into the posi
-
tap connector and
screw the smaller cap into place, securing the wire, at
Arrow A
in
Figure 11
. Tug the wire to assure fitment.
Remove the 10mm bolt & install the ground wire. Reinstall
the bolt shown at
Arrow B
in
Figure 11
.
Cut the rubber plug so the harness can pass through to the
underside of the car, at
Arrow C
in
Figure 11.
Disconnect the battery before performing any
electrical work.
In the trunk, remove the liner to access the harness outlined
in
Figure 10
(located on the passenger rear corner). To
access the harness, it is necessary to partially remove the
fuse box.
Removing the larger cap on the posi
-
tap connector, install
over the red power wire and screw the cap into place.
Shown by the arrow in
Figure 10
.
