1.
Fill the refill bottle with the organic liquid
selected (one or two of full droppers
should be enough), and replace the cap.
2.
Do not fill the cartridge while connected
to the battery, remove by unscrewing
the cartridge anti clockwise.
3.
With the metal tip of the refill bottle, gently pierce
through the rubber cap at side wherethe holes
are, as indicated in the picture above. It’s best
that this is done on an angle to prevent any liquid
leaking out (avoiding the middle or damaging the
coil). Once you can see the metal tip is through
the rubber cap gently squeeze the liquid into
the cartridge, stop filling when it’s 80% full. It’s
tempting to fill it all the way, don’t it can cause
splashback and leakage.
4.
To avoid the first taste to be the coil heating up
put a small drop of your liquid on the coil leave
for 5 minutes before use.
Shown here is the Dual cartridge looking
down from the top.
The coil shown in the middle of the
diagram is what heats up when the Dual is
activated, turning the liquid to vapour.
INSTRUCTIONS
– HOW TO INSERT
LIQUID INTO THE CARTRIDGES
MAINTAINING THE DUAL
1.
To clean the cartridges within the Dual. Start
by removing the mouthpiece, then twisting off
the cartridge separating it from the battery.
Remove the rubber cap and clean under water.
With a small spray bottle filled with water,
spray directly into the cartridge until filled -
empty into a paper towel. Repeat until clean
and leave on the paper towel to dry. Leave
overnight to dry then replace cap and refill.
2.
When refilling, be sure to remove any excess
liquid from the base of the cartridge by
dabbing onto a paper towel.
3.
Liquid may also collect above the cap - remove
the excess with a cotton tip.
It is important to read this manual carefully. The Dual is a
unique product. Do not implement another maintenance
methods, than the one outlined in this manual.