4 |
P a g e
Connect the speaker cables to the correct input as shown in the diagram below
Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers
being connected to this unit, and be sure to connect the channels and polarities correctly.
Peel off about 10mm of sheathing from the tip of the speaker cable, then twist the core wire
tightly
Turn the speaker terminal counter clockwise to loosen it
Insert the stripped cable into the terminal
Turn the speaker terminal clockwise to tighten it (making sure the core is not touching the
back of the AVR)
