- Page - 10 -
ADVANCED WATER ENGINEERING, INC.
Indian Harbour Beach, FL
www.advancedwater.com
B. Drilling a
Ceramic
Tile
Counter
1.
Take off the ceramic layer of the tile using a silicon carbide grinding wheel. Grind away
enough of the material to accommodate a 1-1/4” carbide drill
bit.
2.
Operate the drill at low speeds, especially when the bit is about to penetrate the tile.
C. Drilling Stainless Steel Sinks
1.
Determine faucet locations and center punch the stainless for the drill bit.
2. After drilling a pilot hole using a high speed carbide bit, increase the bit size until you
have drilled a hole at least 1-1/4” in diameter.
Step-by-step assembly:
STEP 1
Read all instructions before beginning installation. Verify that all parts have been received.
STEP 2
Prepare mounting hole:
See instructions from previous column.
Use existing third hole in sink if available.
