OPERATION
Turn the hand hook to retract or extend the awning as your requirement.
Warning:
Stop retracting the awning with excessive forces if already fully retracted.
Pitch adjustment:
A
A
A
D
D
D
J
J
J
U
U
U
S
S
S
T
T
T
I
I
I
N
N
N
G
G
G
T
T
T
H
H
H
E
E
E
P
P
P
I
I
I
T
T
T
C
C
C
H
H
H
O
O
O
F
F
F
T
T
T
H
H
H
E
E
E
A
A
A
W
W
W
N
N
N
I
I
I
N
N
N
G
G
G
CAUTION: DO NOT ATTEMPT TO ADJUST THE PITCH IN THE RETRACTED POSITION
IF YOU ORDERED AN ADJUSTABLE PITCH CRANK.. DO NOT STOP..GO DIRECTLY TO NEXT STEP
•
Extend the awning completely.
•
First identify the pitch adjustment brackets (K). (see diagram below)
•
Loosen the top bolt (P) and bottom bolt (R) (do not remove them, just allow them to be moved) on the bracket at both ends.
This operation requires a 6mm and 8mm Allen wrench.
•
Have your helper(s) hold the front end of the awning.
•
Turn Allen bolt (Q) counter-clock-wise to lower the pitch and clock-wise to raise the pitch on both ends.
•
Once you adjust the pitch to your desired level, tighten up the top bolt (P) and bottom bolt (R).
•
If the front bar is lower on one side, simply loosen (P) on the opposite side bracket and make the appropriate adjustment to (Q).
After you are happy with the results retighten (P).
•
The pitch adjustment range is 0 degrees to 15 degrees.
1
1
1
Y
Y
Y
E
E
E
A
A
A
R
R
R
L
L
L
I
I
I
M
M
M
I
I
I
T
T
T
E
E
E
D
D
D
W
W
W
A
A
A
R
R
R
R
R
R
A
A
A
N
N
N
T
T
T
Y
Y
Y
A. WHO GIVES THIS WARRANTY?
Awntech Corporation
B.
WHO IS ENTITLED TO THIS WARRANTY?
This Warranty applies only to the original purchaser who paid for the product and may not be assigned or
transferred to subsequent owners. This Warranty applies only to products purchased and installed in the US.
C. WHAT ARE THE RESPONSIBILITIES OF AWNTECH CORPORATION UNDER THIS WARRANTY?
Subject to the terms and conditions set forth herein,
Awntech Corporation will furnish replacements for parts found by Awntech Corporation to be defective in design, manufacture or assembly, under each
specific component or product warranty as set forth below.
D. WHAT ARE THE RESPONSIBILITIES OF THE ORIGINAL PURCHASER UNDER THE WARRANTY?
1.
Before any claims may be made under this Warranty, the original purchaser must have paid in full for the product covered under the Warranty,
according to the terms and conditions of the pay-plan defined in the original order. IF THE PURCHASER HAS FAILED TO MAKE FULL PAYMENT, THIS
WARRANTY SHALL BE NULLIFIED AND AWNTECH CORPORATION SHALL BE RELIEVED FROM ANY RESPONSIBILITY OR LIABILITY UNDER THIS
WARRANTY. The purchaser agrees and acknowledges that this Warranty agreement constitutes an executor contract.
2.
The purchaser must use care in installation, maintenance, operation, use, and storage of the product in accordance with the instructions contained in
the owner’s manual. ANY FAILURE TO INSTALL, MAINTAIN, OPERATE, USE AND STORE THE PRODUCT IN ACCORDANCE WITH THE INSTRUCTIONS
CONTAINED IN THE OWNER’S MANUAL WILL NULLIFY THIS WARRANTY AND RELIEVE AWNTECH CORPORATION FROM ANY RESPONSIBILITY OR
LIABILITY UNDER THIS WARRANTY.
3.
Promptly notify Awntech Corporation of any claims.
4.
The purchaser may be required to provide a photograph of any defective parts. The purchaser may also be required to pay a deposit until the
defective parts are returned to Awntech Corporation for inspection. The purchaser must obtain a return authorization form from Awntech
Corporation’s customer service department prior to the return of any merchandise and after having received such authorization, return the part or
product, freight prepaid, to Awntech Corporation.
E. WHAT IS COVERED UNDER THIS WARRANTY?
1. The following components of Awntech Beauty-Mark® models and their accessories (defined as accessories attached to the awning) are covered
under this Warranty, subject to the limitations set forth below. These components have a one (1) year limited (prorated) warranty, against
