9
6. ELECTRICAL REQUIREMENTS & SPECIFICATIONS
IMPORTANT:
Observe all governing codes and ordinances.
•
It is the customer’s responsibility t
o contact a qualified
electrical installer.
•
A 120 Volt, 60 Hz, AC only, fused electrical supply is
required on a 15-amp circuit.
•
DO NOT have a fuse in the neutral or ground circuit.
•
The 3-prong outlet should be grounded. If the power cord
plug is not used, the power cord’s green wire should be connected to ground. Check
with a qualified electrician if you are not sure that the range hood is properly
grounded.
•
DO NOT ground to a gas pipe.
•
The range hood must be connected with copper wire/plug only.
•
The range hood should be connected directly to the fused disconnect (or circuit
breaker) box through flexible armored or non-metallic sheathed copper cable. ETL
listed strain relief must be provided at each end of the power supply cable.
Specifications
Specifications:
Body Design
Seamless Stainless Steel, Satin Finish
Power Rating
120V / 60Hz (USA & Canada standard)
General Input Power
236W (230W + 2x3W)
Motor Input Power
230W
Ampere
2.5 A
Levels Of Speed Control
4 Levels
Airflow (Q/L/M/H)
385CFM / 490CFM / 715CFM / 800CFM
Noise Level (Q/L/M/H)
1.0Sone(40dB) / 2.0Sone(50dB) / 3.0Sone(56dB) / 4.0Sone(60dB)
Number Of Motors
1 Motor
Motor Type
Single Chamber Ultra Quiet
Fan Type
Centrifugal Squirrel Cage
Control Type
Soft Touch Electronic Control Panel with LED Light
Filtration Type
Stainless Steel Baffle Filter
Illumination
3W 12V Maximum
Venting Size
Top, 6 inches Round
Timer
Delayed auto power shut-off timer
