9
6. ELECTRICAL REQUIREMENTS & SPECIFICATIONS
IMPORTANT:
Observe all governing codes and ordinances.
•
It is the customer’s responsibility t
o contact a qualified
electrical installer.
•
A 120 Volt, 60 Hz, AC only, fused electrical supply is
required on a 15-amp circuit.
•
DO NOT have a fuse in the neutral or ground circuit.
•
The 3-prong outlet should be grounded. If the power cord
plug is not used, the power cord’s green wire should be connected to ground. Check
with a qualified electrician if you are not sure that the range hood is properly
grounded.
•
DO NOT ground to a gas pipe.
•
The range hood must be connected with copper wire/plug only.
•
The range hood should be connected directly to the fused disconnect (or circuit
breaker) box through flexible armored or non-metallic sheathed copper cable. ETL
listed strain relief must be provided at each end of the power supply cable.
Specifications
Specifications:
Body Design
Seamless Stainless Steel, Satin Finish
Power Rating
120V / 60Hz (USA & Canada standard)
General Input Power
236W (230W + 2x3W)
Motor Input Power
230W
Ampere
2.5 A
Levels Of Speed Control
4 Levels
Airflow (Q/L/M/H)
485CFM / 590CFM / 815CFM / 1000CFM
Noise Level (Q/L/M/H)
1.0Sone(40dB) / 2.0Sone(50dB) / 3.0Sone(56dB) / 4.0Sone(60dB)
Number Of Motors
1 Motor
Motor Type
Single Chamber Ultra Quiet
Fan Type
2 Centrifugal Squirrel Cages
Control Type
Soft Touch Electronic Control Panel with LED Light
Filtration Type
Stainless Steel Baffle Filter
Illumination
3W 12V Maximum
Venting Size
Top, 8 inches Round
Timer
Delayed auto power shut-off timer
