10
7. INSTALLATION PREPARATION
Test before installing:
•
Please unpack the range hood and accessories carefully. Remove the baffle filters.
•
Check for any dent or damage inside and outside. If found any loosing parts, please remove them.
•
Place the range hood and the Blower unit on a flat stable surface;
connect the Speed Control Cord from the
range hood to the Blower unit’s connector inside the top connection box.
•
Connect the range hood to a designated standard outlet (120-Volt, 60Hz, AC only). Press the power button and the
speed buttons to turn on.
•
Check if any unusual metal touching noise, check the speed variation, and press the Light button to check
the lights.
Verify all functions by referring to Section 9
RANGE HOOD OPERATIONS
. Refer to Section 10
•
Place all supplied parts and required hardware on a flat stable surface and verify the existence of all supplied parts
listed on Section 2
•
Note: The white plastic protective film was removed for sanding polish finishing.
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
CAUTION: If moving the cooking range is necessary to install the hood, unplug the power on an
electric range. SHUT OFF THE GAS VALVE BEFORE MOVING A GAS RANGE.
8. INSTALLATION INSTRUCTIONS
1)
Installation planning
•
Measure the distance between stove top and the bottom of range hood. A distance of 24” to 27” is
recommended. Minimum 24” is required for safety concern.
•
Decide the venting method and the location of the venting pipe from the hood to the outside.
•
Purchase any necessary accessories from a hardware store, such as duct, elbow, reducer, duct tape,
screws, etc.
•
Find and mark the stud locations using a stud finder to plan the mounting locations firmly.
2)
Measure the top vent, speed control cord and the power cord positions, cut the
openings (slightly larger for easy accessible) in the cabinet from bottom to top and
ceiling.
3)
For installing under the cabinet with recessed bottom, attach 4-inch wide wood
filler strips (not provided) on each side.
4)
Puncture the knockout screw holes on the top for screw mounting under the cabinet.
5)
Mount this range hood under the cabinet, 2 people are required for this
installation.
•
Draw power cord and the speed control cord through cabinet access opening
and center the hood beneath the cabinet.
•
From inside of the hood, place screws into the exact center of each knockout
hole and secure to cabinet bottom. Finish tightening all screws until secure.
CAUTION: Make sure the range hood is secure before releasing!