AWS Storage Gateway User Guide
Configure Network Parameters
To set a network address
1. Choose
Configure Network
and press the
Enter
key. The
Configure Network
screen shown
following appears.
2. For
IP Address
, enter a valid IPv4 address from one of the following sources:
• Use the IPv4 address assigned by your Dynamic Host Configuration Protocol (DHCP) server to your
physical network port.
If you do so, note this IPv4 address for later use in the activation step.
• Assign a static IPv4 address. To do so, choose
Static
in the
em1
section and press
Enter
to view
the Configure Static IP screen shown following.
The
em1
section is at upper left section in the group of port settings.
After you have entered a valid IPv4 address, press the
Down arrow
or
Tab
.
Note
If you configure any other interface, it must provide the same always-on connection to the
AWS endpoints listed in the requirements.
API Version 2013-06-30
28