2
14
Pre-drill the four remaining holes for the small casing
plate A (Ø 2 mm). Fix the window plate
6
to the small
casing plate A using the screws
13
(4,0 x 40 mm, figure
L
).
15
Tap the connection support (SW or LW) between the large
and small casing plates A from right to left until it comes
out, so the roof window can be opened again (figure
M
).
16
Pivot the roof window until the hinges are visible on either
side. Use a flat screwdriver to remove the leaf spring from
both hinges. Remove the sash keep of the folding opener (if
present) by loosening the screws and taking the sash keep
out (figure
N
).
17
Attach the window casing plate
5
to the large casing
plate A using 3 bolts
16
(M4 x 12 mm, figure
O
).
18
Slide the closing unit on to the window casing plate
(figure
P
).
19
Slide the chain block fully over the window
plate
(figure
P
). The block will fix itself in place.
20
Screw the closing unit in place with 2 bolts
15
(M4 x 16 mm),
one on the left-hand side and one on the right-hand side of
the closing unit. Do not tighten the bolts entirely so the
closing unit can be readjusted (figure
Q
).
21
Close the window with the remote control figure
R
).
When doing so, hold the closing unit and ensure it
stays the same distance from the window.
Configure closing unit:
20
The closing unit will stop flashing once it is fully closed.
You can adjust the close-position using the adjustment
screw.
If the window is not close enough:
If the window is not close enough (the window moves or a draft
comes through the window), you must turn the adjustment
screw to the left (figure
S
).
For effective operation and a long battery life-span, we advise
not to configure the closing unit too tightly.
If the closing unit does not lock completely:
If the closing unit does not yet close properly, the LED light will
flash. In this case, the unit is too tight.
If the closing unit has been configured too tightly, you must turn
the adjustment screw to the right (figure
T
). Press the close
button on the remote control once again and check whether the
closing unit closes properly. Repeat this process until the unit
closes properly.
AXA Remote 2.0
37-341 (11-13)
EMC 2004/108/EC
3
Remote-controlled window opener
for centre-pivot roof windows
L
4x
4x
M
N
Hinges
Sash keep
Windo
w casing
Windo
w casing
Windo
w
O
3x
P
Q
2x
R
