Oxygen 5 Digital - User Manual
Version 2.5 - 12/22/2010
Axel Technology srl
www.axeltechnology.com
|
FIRST
INSTALLATION RECOMMENDATIONS
13
FUSE REPLACEMENT
The power supply socket has an integral fuse drawer containing the AC power fuse and a spare, both
of the same value.
BEFORE REPLACING THE POWER FUSE, MAKE SURE YOU HAVE THE RIGHT TYPE
OF FUSE FOR THE VOLTAGE TO BE PROTECTED.
USING WRONG FUSE TYPE WILL RESULT IN INSUFFICIENT PROTECTION.
Make sure that the power is sw itched off and the pow er cable is disconnected from the
equipment.
a.
Open the fuse drawer using a small blade screwdriver.
b.
Replace the fuse located at the internal position
c.
Push the fuse socket back into the original position (a.)
Perform the set-up under static control conditions. Static charges are likely to
completely destroy one or more of the CMOS semiconductors employed in the unit.
Static damage will not be covered under warranty.
Basic damage prevention consists of minimizing generation, discharging any
accumulated static charge on your body and preventing that discharge from being sent
to or through any electronic component.
Uninsulated dangerous voltage are inside the enclosure, voltage that may be sufficient
to constitute a risk of shock.
Always disconnect to AC Mains before removing the top cover
