Oxygen 5 Digital - User Manual
Version 2.5 - 12/22/2010
Axel Technology srl
www.axeltechnology.com
|
Oxygen 5 Digital
Engine
25
5.1 IP/Clock configuration
Figure 5: IP/Clock configuration
Here you can setup the network settings to be compatible with the required settings in your situation
and you can set the time zone to where you are.
It’s possible to change the IP, subnet, gateway and DNS server address by clicking on the address.
For more information on IP addressing:
http://en.wikipedia.org/wiki/IP_address
To change the time zone, click on the used time zone (in our example ‘Europe/Amsterdam’). You can
select the desired time zone in the list box.
The Oxygen 5 Digital uses the NTP protocol for accurate clock synchronization. In the section ‘current’
you find the IP address of the used ‘clock master’ and its ‘stratum’. For more information on NTP:
http://en.wikipedia.org/wiki/Network_Time_Protocol
When IP and DNS settings are setup correct, the Oxygen 5 Digital will automatically synchronize to a
pool of time servers. The Oxygen 5 Digital is also able to use a GPS receiver via USB for time
synchronization. At this moment to Oxygen 5 Digital may function if a NTP server for the surfaces.
On the webserver of the control surfaces you now can click on 'optional ntp server' to fill in the IP
address of the ntp server (e.g. 192.168.0.200).
Remember that all changes will become effective after reboot.
