Oxygen 5 Digital - User Manual
Version 2.5 - 12/22/2010
Axel Technology srl
www.axeltechnology.com
|
Oxygen 5 Digital
Engine
42
5.11.1.1 Module preset 1A/1B, 2A/2B, 3A/3B, 4A/4B
Here you select the source, processing preset and routing preset that is used when module preset
1A/1B, 2A/2B, 3A/3B, 4A/4B is selected. After a click on ‘routing’ a popup appears with the routing
possibilities (this depends on the console assignment).
•
Routing Preset
Figure 19: Module routing preset
Ov erride module
If set to no, the module setting will not be affected by this preset. If set to yes, this preset will
change the settings of the module for the corresponding buss.
Lev el
If the override is turned to yes, this will set the send level to the buss for this module when
current preset is selected.
State
If the override is turned to yes, this will set the buss state to ‘on’ or ‘off’ for this module when
this module preset is select.
Pre/Post
If the override is turned to yes, this will set the buss pre or post for this module when this
module preset is select.
Balance
If the override is turned to yes, this will set the buss balance for this module when this module
preset is select.
To all console 1-4 module
With this link you can copy the current settings to the same routing preset (1A/1B, 2A/2B,
3A/3B, 4A/4B) at all modules of the console where this module is assigned to.
•
Ignore module state
When presets are recalled, it checks the module state to prevent recalling ‘onair’ signals. The
preset will wait till the module is switched off air.
If the ignore module state function is switched to yes, the presets will not check the module
state and forces the recall to be done always!
