Oxygen 5 Digital - User Manual
Version 2.5 - 12/22/2010
Axel Technology srl
www.axeltechnology.com
|
Oxygen 5 Digital
Engine
43
5.11.1.2 Processing
This are the programmed processing defaults for the modules. Depending on the startup settings
these processing defaults will be used at startup.
The field ‘Use at source select’ determines if the processing section also is used when there is no
processing preset assigned to the source/module preset, or the processing section in the processing
preset is not overriding the module settings.
The following processing sections are available:
•
Digital Gain level
You can enter a default gain level for each module.
•
Low cut frequency
You can enter a default frequency of the low cut filter.
•
Phase
Set the phase to default settings.
•
Mono
Give the mono settings default values.
•
EQ
By clicking on EQ you can set the default equalizer settings.
•
Dynamics
This setting is used as default
•
Module level
Set the level to default value at startup.
•
Module state
Set the module to on or off at startup.
5.11.1.3 Routing
•
Buss level
You may predefine the send level of a module to the busse s (e.g. Aux send).
•
Buss status
You have to setup the startup status for the busse s. With this setting you set the buss routing
(e.g. Program on/off or CUE on/off).
•
Buss Pre/Post
It’s possible to have pre/post selection per module, the startup setting can be configured here.
•
Balance
You can select the balance of the buss sent.
