AXELL D-MBR 3007-3008-PS NFPA REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
26
UMCD00013 Rev 2.2
© Axell Wireless Ltd
4
Initial Setup and Commissioning
This section describes the setup procedures for the D-MBR PS Repeater. The initial setup
procedure is performed through a Web connection from a computer on the
same subnet
,
using a cross-over Ethernet cable (supplied).
The setup procedure consists of the following steps:
1. Open a local Web session to the Repeater (this requires configuring the
communication parameters of the computer used).
2. If you are not familiar with the Axell Web Access application, we suggest you quickly
review the section on Navigating the Web GUI Application. It is only a couple of
pages and you will find it useful.
3. Define the
Global Settings
for each of the supported bands, and determine the
number of filters assigned to each band.
4. Enable and configure the relevant channels (Filter Switch tab).
5. Verify that no Alarms are generated.
6. Set the Repeater time and date.
7. Configure the external alarms.
8. (If relevant), configure the System IP Address.
4.1 Open a Session to the Repeater
4.1.1 Connect the Repeater to the Computer
To open connect the Repeater to the Computer
Connect the Ethernet cable (supplied) between the front panel
Ethernet
port (see figure
below) and the computer Ethernet port.
Note:
When performing a local connection, use the supplied Ethernet cross-cable (PN:
1579909499).
Figure 4-1. Connect Computer to Repeater via Ethernet
4.1.2 Configure the Computer Network Parameters
Configure the computer network parameters to communicate with the Repeater. Note that
the procedure may vary slightly depending on the operating system installed on your
computer. The following procedure is for Windows 7 OS.