appears. The PIN is
0000
.
6. The hand set is now registered.
Select the hand set language
1. Press the
big middle button
to enter the menu.
2. Select
Settings - Language and scroll to the desired language, en with
Select.
IP address
The base stations supplied from Axema is pre configures with the IP address
10.0.0.61.
To see the base stations IP address, press the blue button to call a hand set, in
which the IP address is visible. If 0.0.0.0 is displayed, no IP address has been
registered and the base station has to be connected to a network with DHCP Make
sure that the base station has been assigned an IP adress by calling a hand set
again.
Log in to the base station
1. Connect a computer to the base station using a network cable. The inlet is
on the side of the base station
2. Enter the
of the base station in a web browser. The factory
default is 10.0.0.61.
3. In the log in window, enter PIN and session language. The factory default
PIN is 0000.
The computer and base station has to be in the same sub net. The network
card settings has to be configured to connect to the same sub net as the
base station.
4 (8)
Manual N510 and C620H
