11
SETTING PEDESTRIAN POSITION
FOR OPENERS WITHOUT AN ENCODER FITTED.
Note:
Before setting the pedestrian access position the door must
be in the fully closed position. As with the Setting Travel
Limit procedure, a transmitter can be used to complete the
pedestrian position setting procedure.
STEP 1. NAVIGATING TO “SET PEDESTRIAN MENU”
1.
Press PREV to navigate to the Menu 10 (
Fig. 16
).
2.
Press SET - MENU 10.1 is displayed.
3.
Press NEXT to go to MENU 10.2.
4.
Press SET to enter Set Pedestrian procedure.
STEP 2. SETTING PEDESTRIAN POSITION
1.
Press OPEN to move gate to desired pedestrian access position.
(Or press button 1 on transmitter) (
Fig. 17
).
2.
Press SET to record position.
(Or press button 2 on transmitter).
STEP 3. PEDESTRIAN POSITION SET
The controller will return to the MAIN SCREEN with the gate
status shown as being in pedestrian access mode (
Fig. 18
).
MENU
10.2
Set
Pedestrian
PRESS
/
/\
\\
\/
/
to
Pedestrian
Position,
SET
PRESS
Ped’n
Access
P
Pr
re
es
ss
s
<
<>
>
t
to
o
A
Ac
cc
ce
es
ss
s
M
ME
EN
NU
US
S
PRESS
PRESS
FIG. 16
OR
FIG. 17
FIG. 18
INVERTER
The variable frequency inverter converts 240V single phase power
into three phase to run the frive motor. It’s other main function is
to control the soft start/soft stop (accelerate/decelerate) speed.
The table at right in indicates the factory preset and the range.
To change accelerate/decelerate speed.
1.
Press DSP/FUN button to display F06.(
Fig. 19
)
2.
Press DATA/ENT to enter modify mode. Display should show
factory default - 50Hz.
3.
Press
S
or
T
to increase or decrease the frequency.
4.
Press DATA/ENT to set.
FUNCTION
FN UNIT RANGE DEFAULT
Accel./Decel. Speed
6
0.1 Hz 30 - 70Hz
50Hz
FIG. 19
