25
ACCESSORIES INSTALLATION
This opener does not feature an inherent obstruction
detection (reversing) system. For safety a PE Beam MUST be
fitted.
FITTING PHOTO ELECTRIC BEAM
Locate the Photo Electric (P.E.) Beam in a strategic location in the
gateway. ATA recommend that the sensor is placed 150mm above
the floor level and as close as possible to the door opening.
Remove the shunt from the P.E. input and connect as per the
wiring diagram at right. make sure that the sensors are correctly
aligned as per the instruction manual. supplied with the P.E. Beam
kit. See Page 14 for set up of Auto-Close times.
Warning: When using Auto-Close mode and P.E. Beams the
gateway must be clear of all obstructions and persons at all
times. The location of the P.E. Beam and the manner in which
it is installed might not give safety protection at all times.
Check to make sure that the height of the sensor and type
used offers maximum protection possible.
FITTING SOLENOID OR MAGNETIC LOCKS
Install the lock mechanism on the gate as per the manufacturers
instructions. The wiring diagram at right is a representation of a
typical lock with a bias for normally closed contact.
See Page 15 for Lock Times set up.
FITTING COURTESY LIGHTS
An AC or DC courtesy light can be activated via an output on the
gate opener control board. Connect the light as per the diagram at
right. See Page 15 for Light Times set up.
Warning: A qualified electrician must perform the
installation where 240V AC power is used.
Remove
P.E. Shunt
FIG. 58
FIG. 59
FIG. 60
Light Relay Module
Light Power
Supply
