5: E
le
m
en
t O
pe
ra
tio
ns •
76
©2016 Axia Audio- Rev 1.8.1
key displays the Aux Sends screen.
Figure 5-12: Aux Sends menu screen.
»
Select/Exit:
(2-Fader Monitor module only)
This control changes which AUX send the other
control is adjusting. Pressing this knob will exit
the Aux Sends Menu screen.
»
Send A/B/C/D:
Rotate these knobs to adjust the
level of the audio you’ll be sending to any or all
of the four Aux Send buses.
»
Pre/Post Fader:
Pushing any of the four
Send
SoftKnobs toggles the activity state of that par-
ticular
Send.
The state is indicated in the display
above.
*
On Pre
sends the source assigned to the fader
to the selected Aux Send bus prior to having
its gain adjusted by the fader (fixed level).
*
On Post
sends the source assigned to the fad-
er to the selected Aux Send bus after having
its gain adjusted by the fader (variable level).
*
Off
sends no audio to the Aux Send bus.
»
Pressing
Aux Sends
again returns to the Chan-
nel Options screen.
•
Feed To Source Key
If the assigned source (i.e., a codec or phone hybrid)
has an associated backfeed or mix-minus, pressing this
key allows the board op to change the audio supplied
through the backfeed. This selection is normally pre-
set when a Source Profile is constructed (see Chapter
3: Working With Sources, for information on Source
Profiles), but can be modified on-the-fly.
Figure 5-13: Feed to Source menu screen.
»
The
Select/Take
knob, when rotated, scrolls
through the list of available audio sources that
can supply backfeed or mix-minus.
*
Automatic
backfeeds audio from the Phone
