2
Quick Start Guide
Press and hold the METER button (D) until the Studio display (E) changes to a menu.
Rotate the Studio knob (F) to highlight NETWORK, press the knob in to enter.
Rotate the knob to highlight IP ADDRESS, press the knob to enter.
The display will show the 4 octets of an IP address. Rotate the knob to highlight an
octet, press to enter edit mode, rotate the knob to increment or decrement the value,
press the knob to end edit mode. Do these steps to edit the IP address of the device.
When the IP address is complete, rotate the knob to the top of the menu, two dots are
shown, and press the knob to exit IP ADDRESS.
Repeat the procedures for netmask and gateway based on the needs of your network. After all NETWORK settings have
been edited, select the SAVE menu item. The screen will return to its default function and the surface is ready for system
configuration.
Using a PC connected to your studio network, launch a web browser and enter the assigned IP address into the browser’s
address bar. When prompted for authentication enter user name “user”, password is left blank.
