Chapter 3 |
29
Audio Configuration
Record Mode
The surface has a record button and the function of that button is defined here.
♦
Disabled
- effectively the button does nothing and these is no Record mode
♦
Enabled
- toggle the historical Axia record mode. When in record mode, the monitor section will change to the
specialized Record mix, muting the CR monitors, and trigger GPIO. Refer to GPIO section for GPIO-specific
information.
♦
CR Ready
- use to indicate through GPIO of a rady condition. GPO pin 5 will latch in this mode when in record mode.
♦
CR Ready with Auto-Reset
- same as CR Ready but the latch will reset the moment a mute state is triggered.
♦
GPIO Button
-treat the button as a GPIO button. GPO pin 1 of a port will follow the button press. Inverse, GPI pin 11
of the GPIO port will trigger the illumination of the Record button.
The last three require a Logic port value to be applied (number between 1 and 32767).
User Interface
♦
Timer Mode
defines if the count up timer on the overbridge is triggered manually or by those source profiles with
timer control enabled.
♦
Preview Interlock Mode
allows for the function of pressing a second Preview button that would release the earlier
Preview button. If not enabled, each Preview button pressed would need to be pressed again to remove the channel
from preview.
♦
Switchable Meter Source
defines what source the last audio meter on the overbridge follows.
♦
Logic Port for Timer
allows for remote manual control of the timer through GPIO. Refer to the GPIO section for
specifics.
♦
Talk to CR Level
defines the gain (attenuation or amplification) of the Talk to Control Room audio.
♦
Control lock
allows control of the selected item. Any item not checked will not function for the operator.
Capture a Profile
Pressing the Capture button at the root Shows page will capture the current state of the console and load those values to the
Show Edit page, allowing you to make changes before saving or simply saving the current configuration.
Changes
The page will show what is different between profile settings and active settings and give options in storing the volatile active
settings to memory.
