13
INSIDE THE OVEN
After waiting for the oven to internal cooling, please use wet dishcloth wiped the remains of
the oven. Because of the enamel layer and ware metal surface under the high temperature,
so there will be some faded. This is normal and does not affect the function. Don't try to use
the rough friction pad or high strength cleaner to make up for this kind of faded. The enamel
surface use warm water to clean. Do not use steel wire ball, corrosive and abrasive cleaner,
or sharp objects, such as knife, scraper, it can damage the enamel layer.
CLEAN THE OVEN DOOR AND GLASS PANEL
Use mild cleaning fluid, sponge cleaning and drying the oven door. Do not use steel wire
ball or corrosive cleaner and scraper, it will damage the surface of the oven. You can use
completely removed the oven door to clean. Do not use grinding is strong, sharp or sharp
items cleaning glass panel, it will scratch the glass surface, and glass panels after injury
may be damaged due to the change of the temperature of the oven. After completion of
cleaning, glass panel is installed on the oven door first, and then install the oven door, be
careful not to install backwards glass panel. Oven glass panel must be installed correctly,
otherwise, please do not use the oven.
A. Removing the oven door:
(See figure 1).
1. Pull the oven door to the horizontal level. (figure A)
2. Move the latch of hinges on both sides to the fully open position (See figure B), and
hold the door.
3. Push up the door. (figure C)
4. Push the door back to about a 15 degrees angle; lift the door up until the hook take out
from the card slot.(figure D)
Figure A
Figure B
Figure C
Figure D
Catch
Figure 1
