15
: V
m
ix C
on
tr
ol •
76
© 2017 Telos Alliance - Rev 1.2
The interface will now update to display the state of the virtual mixer selected. You can use the drop-down lists to
switch between different Vmixers.
Each Vmixer has 5 input channels and a master fader. The master fader is labeled as master and has the red fader.
The meters for the input channels display the real-time metering of the source assigned to each of the faders. This
metering is pre-fader so it is showing you the level of incoming audio. The meter next to the master fader is
displaying the level at the output of the virtual mixer and is therefore post Master fader.
Dragging a fader on the screen up or down will adjust the VMixer channel’s gain.
Clicking the On/Off buttons will turn a fader on and off. It is important to note that turning a virtual mixer fader
on and off is subject to the fade up and fade down time parameters. These can be changed by clicking on the fields
next to the up arrow or down arrow in the Fade Time section. Times are entered in seconds. So if you have a fade
up time of 1.2 seconds, when you click the On button the audio will fade in to the level defined by the fader over
the course of 1.2 seconds. Then the fader control will dynamically allow you to control the level. The same is true
when turning the fader off. Clicking the off button will fade the audio out dependent on the fade down time.
