4
r.
3.
Turn on the transmitte
Note:
Power to the vehicle is controlled by
connecting / disconnecting the battery.
4.
Connect the battery to the ESC.
5.
Install the body and body clips.
2.
Install the battery.
1.
Remove the body clips and body.
DTXP4175 USB NiMH Charger and DTXC2031 Battery Instructions
Before using your factory assembled RTR, review the entire instruction manual to become familiar with the vehicle.
This is a quick start guide for care and usage of the charger and battery that comes with the vehicle.
DTXP4175
- Duratrax Onyx USB Charger
NiMH 6C Mini Connector
DTXC2031
- Duratrax NiMH Onyx 7.2V
1300mAh Flat Mini Connector
CAUTION: The DTXP4175 charger is for use
with 6-Cell 7.2v NiMH batteries ONLY and
should not be used with any other batteries.
CAUTION: Never leave the battery unattended
while charging. Always disconnect the battery
and unplug the charger when finished charging.
CAUTION HOT!!!
NiMH batteries may become hot while charging.
Allow to cool before handling the battery.
When using the DTXP4175 charger, the DTCX2031 battery should fully charge in 2-3 hours.
• Remove the battery from the vehicle
before charging.
• Place the battery on a fire resistant surface.
• Avoid any contact with water or other fluids.
1. Connect USB connector to USB power on
PC or USB AC wall adapter.
2. Connect battery to mini connector.
3. Charger will automatically begin charge
process.
Red LED: Charging
Green LED: Finish Charging
Summary of Contents for YETI JR.
