⦁
Connect the power cord to an appropriate wall outlet.
⦁
Configuration
The device is configured via the graphical user interface of the integrated web
interface.
To access the user interface, you need a standard PC/laptop with a network
interface and the actual version of the installed web browser. To connect the network
interface of the device to the computer, you need a commercially available network
cable.
The HTTP protocol is used for communication allowing a worldwide remote
maintenance of the systems at various locations via the Internet. Access protection
is implemented by means of the password prompt.
The following values are preset ex factory:
⦁
IP address:
192.168.0.168
⦁
Subnet mask: 255.255.255.0.
The computer and the headend must be in the same subnetwork. The network part
of the IP address of the computer must be set to 192.168.0. and the subnet mask
must be set to 255.255.255.0.
The host part of the network address is required for the identification of the devices
and can be assigned in the subnetwork only once. You can allocate to the computer
any not allocated host address between 0 and 255.
Hint:
Change the IP address and the subnet mask of your computer accordingly. (e.g.: IP
address:192.168.0.11 and subnet mask: 255.255.255.0)
Control panel > Network connections > LAN connection >Properties > Internet
protocol version 4 TCP/IPv4 > Properties > Use the following IP address:
⦁
Click OK to save.
8