4.2.
CI menu for RFQ-845CI and RFO-845CI
In the CI menus, settings of CA modules can be made for RFQ-845CI and RFO-845CI. The buttons for opening
the CI menu will be activated after the modules have been plugged in and initialised.
Click one of the buttons.
The corresponding CI menu is displayed.
4.2.1.
Using CI menu
The content of the CI menu depends on the CAM manufacturer and the card being used. Depending on the
manufacturer, various settings are possible. Information on validity and authorisation are the most important.
Please observe the operating instructions provided by the manufacturer.
According to used CAM different settings can be done. Most important is getting information about
authorisation.
The input and navigation field is used for navigation within the CI menu.
Use
Up
or
Down
to reach a higher or lower selection point.
Use
OK
to enter a corresponding sub menu or confirm a selection.
Use
Menu
to come back to the next superordinate level.
Use
Exit
to leave the menu.
2016-10-31 | Technical changes, design modifications, errors and misprints are subject to change without prior notice.31
Active buttons for
the CI menu.
Cursor position
The Content depends on used
CAM
Input and navigation field
