2
WARRANTY
This instrument is warranted to be free from defects in material and workmanship for a period of one
Lear. Any instrument found defective within one year from the delivery date and returned to the factory
with transportation charges prepaid, will be repaired, adjusted, or replaced at no charge to the original
purchaser. This warranty does not cover expandable items such as batteries or fuses. If the defect has
been caused by a misuse or abnormal operating conditions, the repair will be billed at a nominal cost.
SAFETY INFORMATION
The digital multimeter has been designed according to IEC-61010 concerning electronic measuring
instruments with a measurement category(CAT II 600V) and Pollution degree 2.
WARNING
To avoid possible electric shock or personal injury, follow these guidelines:
a.
Do not use the meter if it is damage. Before you use the meter, inspect the case. Pay particular
attention to the insulation.
b.
Inspect the test lead for damage insulation or exposed metal. Check the test lead and test probe
for continuity. Replace damage test lead before you use the meter.
c.
Do not use the meter if it operates abnormally. Protection may be impaired. When in doubt,
have the meter serviced.
d.
Do not operate the meter around explosive gas, vapor or dust.
e.
Do not apply more than the rated voltage, as marked on the meter, between terminals or
between any terminal and earth ground.
f.
Before use, verify the meter’s operation by measuring a known voltage.
g.
When measuring current, turn off circuit power before connecting the meter to the circuit.
Remember to place the meter in series with the circuit.
h.
When servicing the meter, use only specified replacement parts.
i.
Use caution when working above 30V ac rms, 42V peak, or 60V dc. Such voltages pose a shock
hazard.
j.
When using the probes, keep your fingers behind the finger guards. Never use hand or skin to
touch the probes and any live conductor.
k.
When making connections, connect the test lead before you connect the test probe. When you
disconnect them, disconnect the test probe first.
