NA580 Series User
’s Manual
12
Hardware and Installation
2.3
Jumper Settings
Jumper is a small component consists of jumper clip and jumper pins. Install jumper clip on 2
jumper pins to close. And remove jumper clip from 2 jumper pins to open. Below illustration
shows how to set up jumper.
This section provides the information about jumpers and connectors of NA580 Series. Properly
configure jumper settings on the main board in this appliance to meet your application purpose.
Below we list a summary table of all jumpers and default settings for onboard devices.
Jumper
Definition
Jumper Setting
JP1
JP2
JP3
LAN Bypass Trigger When
Power On
(1-2)/(1-2)/(1-2)
:
Mother board/SEGN1 ~2 Bypass as same as Power Off status
(1-2)/(1-2)/(2-3)
:
Mother board/SEGN1~2 Bypass Disable(Default)
(1-2)/(2-3)/(2-3)
:
Mother board/SEGN1 ~2 Bypass Enable
JP4
Clear CMOS Setting
1-2
:
Normal (Default)
2-3
:
Clear CMOS
JP6
Auto Power Button Mode
Selection
1-2
:
Always Off
No Jumper
:
Always On (Default)
JP8
TACT SW1 Selection
1-2
:
Power button On/Off
2-3
:
Reset (Default)
4-5
:
GPI
Summary of Contents for NA580 series
