Section 5: Using the AXIS 240
AXIS 240 Users Manual
66
3.
To open the connection, enter:
The latter variation on this command causes the AXIS 240 to
temporarily have the IP address 192.168.3.219. If an address is not
specified, as displayed in first form of this command, the unit will
then use its default address that was previously assigned using
arp
.
Please note that you will probably have to be
root
user to
establish the connection. The modem will try to connect and the
PPP process will then fork off into the background. A shell
prompt will be returned immediately. You may suppress this
behavior by giving the switch
-detach
.
4.
After approximately 20 seconds, the connection should be ready for
service. You should then try pinging the AXIS 240, and make sure
that it is online. The ping response times should be similar to those
below:
5.
Type the following to terminate the connection:
pppd connect '/usr/sbin/chat -f DIAL_240' 115200
/dev/modem
or
pppd connect '/usr/sbin/chat -f DIAL_240'
:192.168.3.219 115200 /dev/modem
64 bytes from 192.168.3.219: icmp_seq=0 ttl=15
time=197.0 ms
64 bytes from 192.168.3.219: icmp_seq=1 ttl=15
time=180.0 ms
kill -TERM ‘cat /var/run/ppp0.pid‘
Summary of Contents for AXIS 240
