Appendix B: The Parameter List
116
AXIS StorPoint CD User’s Manual
[SNMP]
GetCommunityName
= public
Specifies the community that has read only access to all
supported SNMP objects except writeCommunity,
SupervisorPassword and ftpPassword. It corresponds to the
readCommunity SNMP object.
TrapDestination
= 0.0.0.0
Specifies the Internet Address which SNMP traps are sent to.
It corresponds to the trapAddress SNMP object. Default is
0.0.0.0
, i.e. all SNMP traps are disabled.
TrapCommunityName
= public
Specifies the community for all generated SNMP traps. It
corresponds to the trapCommunity SNMP object.
SystemContact
=
Optional entry which should be in plain text and may be used
to show the name of the system contact person.
SystemName
=
Optional entry which should be in plain text and may be used
to show the name of the location of the system.
SystemLocation
=
Optional entry which should be in plain text and may be used
to show the name of the location of the system.
AuthenticationTrap
= disabled
Disables the SNMP authentication failure traps. It
corresponds to the snmpenableAuthenTraps (MIB-II) SNMP
object.
[NetWare]
NWEnable
= yes
Enables NetWare support.
Frame_802.2
= auto
Enables the 802.2 frame type.
Frame_802.3 =
auto
Enables the 802.3 frame type (Ethernet versions only).
Frame_EthernetII
= auto
Enables the Ethernet II frame type (Ethernet versions only).
Frame_SNAP
= auto
Enables the SNAP frame type.
NetWareIP_Enable
= no
Enables NetWare over the IP protocol.
NetWareIP_DSS_Server
=
The Internet address of the DSS server.
ServerName
= AXISnnnnnn_NW
NetWare server name to be presented to the NetWare
clients. Default is AXIS
nnnnnn
_NW where
nnnnnn
are the last
six digits of the serial number.
InternalNetAddress
= nn-nn-nn-nn
Internal network address. Default is
nn-nn-nn-nn
where
nnnnnnnn
are the last eight digits of the serial number.
BurstMode
= on
Burst mode enable.
ShowAllVolumes
= yes
Shows all drives and CD-ROMs also at SYS level.
BinderyEnable
= yes
Enables bindery mode login. When using NDS, set to
no
in
order to increase system security. The supervisor can always
login in bindery mode even if this parameter is set to
no
.
BindAuthentication
=
Name of the server used for authenitcating clients.
NDSEnable
= yes
Enables NDS mode.
NDSTreeName
=
Name of the tree where you wish to install the StorPoint CD.
NDSServerContext
=
Distinguished name of the context in the NDS tree where you
wish to install the StorPoint CD, e.g.
Corp.Acme
.
NDSAdminName
=
Distinguished name of a user or administrator with Supervisor
or Create rights to the context where you want to install the
StorPoint CD, e.g.
Admin.Acme
.
Parameter name
Value
Description
Summary of Contents for AXIS StorPoint CD
