Section 4: Setting Up - NetWare
50
AXIS StorPoint CD User’s Manual
Accessing CD-ROMs in NetWare
When accessing your StorPoint CD through NetWare, you use the
same procedures as accessing any other NetWare file server. This
section gives you examples on how to access the StorPoint CD from
Novell’s clients for Windows 95, Windows NT, Windows for
Workgroups and DOS.
The procedures are very similar when you use bindery mode or NDS
mode. The main difference is that in the case of bindery mode, you
will be asked to enter your user name and password when logging in to
the StorPoint CD.
Notes:
❏
The examples below assume that you use the default NetWare
server name
AXIS<nnnnnn>_NW
, where
<nnnnnn>
are the six last
digits of the StorPoint CD serial number. If you have changed the
server name, use the new name where the examples refer to the
default name.
❏
Alternatively, login scripts can be used to automate and distribute
access to the CD-ROMs. To map the networked CD-ROMs, the
attach/map
(in NetWare 3.x) or
login/map
(in NetWare 4.x)
commands are normally used.
❏
To enable the StorPoint CD to be seen by the NDS tree, you
must change the settings in the configuration
file
config.ini
,
as
described in “
Installation as an NDS Server
” on page 42.
❏
In Windows 95 and Windows NT, your StorPoint CD is
compatible with the MediaAgent software. See “
MediaAgent
CD-ROM Management Software
” on page 92.
Summary of Contents for AXIS StorPoint CD
