Appendix A: Parameter List
StorPoint NAS 100 User’s Manual
74
Appendix A Parameter List
This section includes the StorPoint NAS parameter list. It also explains
the StorPoint NAS directory structure and how to edit the
configuration settings.
The Configuration File
This table shows the parameter list stored in the
config.ini
file
located in the
System/ServerProperties
folder, see the “
” on page 79. The middle column shows the default values,
when applicable. The right-hand column gives a brief description of the
parameters.
Parameter name
Value
Description
[Server]
HardwareAddress
= 00:40:8c:39:30:44
The StorPoint NAS hardware address. Default is the
serial
number
. You can set a Locally Administrated Address. The
value shown is an example only.
Date
= 99-09-10
yy-mm-dd, enter the date followed by ! to set manually
Time
= 12:00:00
hh:mm:ss, enter the time followed by ! to set manually
FactoryDefaults
= no
Set to
configuration
,
volumeProperties
or
all
.
Restart
= no
Set to
yes
to restart the StorPoint NAS.
TimeZone
= UTC
Must be set to the time zone that the StorPoint NAS is
operating in. Refer to “
TimeSyncSource
= None
Specifies the time source for the StorPoint NAS. Set to
NDS
for the NetWare network. Set to
NTP
for UNIX and SMB
over TCP/IP. Set to SMB for NT.
ServerPassword
= pass
The Supervisor, Administrator or Root user password used
for basically all protocols; i.e. HTTP, NetWare bindery,
SMB user level, SNMP and FTP. Once written into the
configuration file, the password will not be shown but
replaced with eight *’s, representing the password.
Shut Down
= no
Set to
yes
to shut down the StorPoint NAS.
NetworkSpeed
= auto
The network speed is automatically detected by the
StorPoint NAS.
[SCSI]
SCSITermination
= on
Always on.
Disconnect_Reselect
= on
Set to
off
to disable the disconnect/reselect function in the
disc drives.
BusMode
= Ultra
Specifies the transfer mode on the SCSI bus:
Asynchronous
,
Synchronous
,
Fast-10 or Ultra
.
[IP]
InternetAddress
= 192.36.253.80
The StorPoint NAS IP address.
