StorPoint NAS
100 User’s Manual
Appendix B: Troubleshooting
89
FTP
To restore the default settings using FTP:
1. Log in to the StorPoint NAS with the command:
ftp <IP address>,
where
<IP address>
is the name or IP
address assigned to your StorPoint NAS.
2. You will be prompted for user id and password. Use the user id
root
,
which has the default password
pass
(
root
is the user id with the
highest priority).
3. Restore the default setting with the command:
get defaults
The unit will then automatically restart.
4. Log out using any of the commands
quit
,
bye
or
exit
depending on
your FTP version.
Push Button
To restore the default settings using the Push button:
To restore default settings using the Push button.
1. Press and hold the Push button.
2. Start the StorPoint NAS.
3. Wait until the Status indicator flashes yellow (one flash/second).
4. Let go of the button at least two seconds.
5. Press and hold the Push button again until the Status indicator
shows a steady yellow light. This may take 5-6 seconds.
6. Restart the StorPoint NAS. The StorPoint NAS is now reset to factory
default settings.
Push button
