Operating Instructions
13
MAKE SURE THE BELT IS INSERTED
CORRECTLY INTO THE PULLEY
GROOVES!
Control Box
Position
Spindle Speed Chart RPM
1
LOW
250
720
2
MEDIUM
600
1,700
3
HIGH
1,200
3,550
MOTOR
SPINDLE
3
2
1
POL
Y V-BEL
T
POL
Y V-BEL
T
H
M
L
4. Release the clamping handle and press down the motor
to retention the belt, secure in place.
5. Replace the motor pulley access plate and close the
headstock access panel.
1. The control box comprises a Forward/Reverse switch,
ON/OFF NVR buttons and a variable speed control dial. Before
switching on make sure the indexing pin is disengaged and
the speed control dial is turned down to low, see fig 28-29.
Fig 28-29
2. Select ‘Forward or Reverse’ on the selector switch, DO
NOT change direction while in operation, see fig 30.
3. Make sure the work piece is secure and all tools are clear of
the work area. Switch on the mains supply and press the NVR
‘GREEN’ button to start the lathe, see fig 31.
4. Increase the spindle speed, the reading will be displayed on
the digital readout indicator, see fig 32. When operation is
completed reduce the speed down to ‘LOW’ and press the
NVR ‘RED’ button to stop the lathe, see fig 31. Switch off the
mains supply.
Fig 30-31
Fig 32
