9
Assembly Instructions
Assembly 2
While holding the lathe bed extension (H), secure using
the four the 3/8” Hex bolts and washers (d)
Figure 15
Remove the tailstock stop “ROD” and place safely aside
Figure 16
-17
d
H
1. Line up the holes in the lathe extension (H) with
the threaded holes in lathe stand (F) and secure
using the 3/8” Hex bolts and washers (d), see figure
18.
Figure 18
Using the 3/8” Hex bolts and washers (d), secure the lathe
extension in position
H
2. Release the headstock lock and slide the headstock
down to the end of the lathe bed and lock in position.
Slide the tool rest assembly onto the lathe extension
(H), undo the tool rest locking handle and remove
tool rest. Locate the tool rest extension (I), slot the
tool rest extension into the machined recess and
tighten the clamping handle.
3. Loosen the clamping handles on the tool rest
extension (I) and slot the tool rest into the extension,
tighten the tool rest locking handle. (See figure 19)
Figure 19
d
I
H
Tool rest
Tool rest lock
Tool rest assembly
Summary of Contents for 502703
