Assembly
8
2. Loosen the collet chuck using the ‘C’ spanner (I) and push rod
(B), loosen the tailstock locking handle and move the tailstock
assembly to the end of the lathe bed, see fig 16-17.
3. Insert the pen mandrel shaft into the collet chuck (F) and
securely tighten, see fig 18.
Fig 16-17-18
4. Slide one of the mandrel spacers and bushings onto the
shaft until they are up against the collet chuck (F). Prepare
your project blank/s, insert the blank onto the shaft. Introduce
the remaining two bushings and the mandrel spacer onto the
shaft, slide the tailstock assembly up until the mandrel shaft
inserts through the hollow centre of the Evolution Revolving
Live Centre (G). Make sure the mandrel spacer is flush against
the revolving centre. Tighten the tailstock locking handle to
secure the assembly in place, see fig 19-20.
5. Loosen the banjo and tool rest locking handles, position the
tool rest, (C or D) as close as possible to the project blank/s and
secure in place, see fig 21-22.
NOTE: Make sure the tool rest is centred with the blank/s.
Fig 21-22
150mm Tool rest (C)
Pen mandrel two blanks setup
80mm Tool rest (D)
Fig 19-20
Mandrel spacer
Mandrel spacer
Mandrel spacer
Mandrel spacer
Bushing
Bushings
Bushings
Project blank
Project blanks
Mandrel shaft
B
I
G
Tailstock locking handle
Summary of Contents for AT150PPL
