Positioning the Machine
20
Ascertain the orientation of the machine and move it to its
desired position in the workshop. Ensure that the machine is
positioned to allow sufficient clearance all round to cater for
the maximum length of timber you wish to machine.
The machine should be positioned on a flat level surface.
Manoeuvre the machine to the chosen location, then carefully
lower the machine down.
SAFETY WARNING!
The WS1000TA Spindle Moulder is a heavy piece of
equipment. You are advised to seek help or the use of some
form of lifting device, (hoist, engine crane etc.,) before you
attempt to lift or move this machine.
218kg
Setting the Fence
The fence is a two piece adjusting system. Each fence is
independently adjustable to compensate for different
cutting thicknesses. Make sure the fence is square to the work
surface, place a 90° square up against the fence and check it is
perpendicular to the work surface. If adjustment is required
turn the fence adjusting knob (a) until it is correct, see fig 44-
45-46.
Fig 44-45-46
Place a straight edge up-against both fences, loosen the fence
advancing clamping handles (b) and turn the fence advancing
knobs (c) until both fences are aligned, see fig 47.
Fig 47
a
b
Straight edge
Square
c