Setting the Fence/Changing the Cutter Block
22
Fig 53-54
Loosen the sliding table clamping nut (a). Slot the feeler gauge
down the gap between the two tables from one side and
adjust until the gap is set between (0.5 to 2mm), repeat the
procedure for the opposite side. Retighten the nuts (a) to
secure the table in position, see fig 53-54.
Sliding Table Clearance
Feeler gauge
a
Changing the Cutter Block
Raise the spindle to the maximum height by unlocking the
rise/fall locking handle (A), turning the spindle moulder
rise/fall handle (B) clockwise then lock in place, see fig 55-56.
Using a 19mm spanner remove the bolt & clamping block (C),
spacing collar/s (D) and clamping washer (E) and place them
safely aside, remove the cutter block, see fig 57. Check the new
cutter block for damage,sharpness etc. Fit the new cutter block
on the arbor as low as possible, see fig 58-59. Watch the
direction of rotation (counter-clockwise) when mounting the
cutter. Replace the clamping washer (E), spacing collar/s (D),
clamping block (C) and bolt. Tighten securely.
Fig 55-56-57
A
B
C
D
E
19mm spanner
Fig 58-59
Cutter block
E
C
D
