Specific Safety Precautions
7
General Safety Notes
• Woodworking machines can be dangerous if not used properly.
Therefore the appropriate general technical rules as well as the
following notes must be observed.
• Read and understand the entire instruction manual before
attempting assembly or operation.
• Keep these operating instructions close by the machine,
protected from dirt and humidity, and pass them over to the
new owner if you part with the tool.
• No changes to the machine may be made.
• Daily inspect the function and existence of the safety
• In addition to the safety requirements contained in these
operating instructions and your country’s applicable regula-
tions, you should observe the generally recognized technical
rules concerning the operation of woodworking machines.
• Any other use exceeds authorisation.
• In the event of unauthorised use of the machine, the
manufacturer renounces all liability and the responsibility is
transferred exclusively to the operator.
appliances before you start the machine.
• Remove all loose clothing and enclose long hair.
• Before operating the machine, remove tie, rings, watches,
other jewellery, and roll up sleeves above elbows.
• Wear safety shoes; never wear leisure shoes or sandals.
• Always wear the approved working outfit.
• Do not wear gloves while operating the machine.
• For the safe handling of cutting tools wear work gloves.
• Control the stopping time of the machine, it may not
exceed 10 seconds.
• Remove cut and jammed work pieces only when the
machine is at a complete standstill and motor is turned off.
• Install the machine so that there is sufficient space for safe
operation and work piece handling.
• Keep work area well lit.
Code 501209
Model AT200SM
Rating Trade
Power
2.8 kW 230V 1ph
Spindle Travel
100 mm
Spindle Diameter
30 mm
Spindle Speed
1,800, 3,000, 6,000 & 9,000 rpm
Max Spindle Projection above Table
100 mm
Max Tooling Diameter Above Table
200 mm
Max Tooling Diameter Below Table
180 mm
Table Height
900 mm
Table Size
1,000 mm x 360 mm
Min Extraction Airflow Required
1,000 m³/hr
Noise Level dB(A)
77.2dB(A)
Dust Extraction Outlet
2 x 100 mm
Overall L x W x H
1,010 mm x 690 mm x 900 mm
Weight
218 kg
Specification
