Assembly
10
collar over the column and slide it down onto the top of the
rack. Lock it in place with the grub screw, ensuring that it has
captured the upper end of the rack securely, but not too tight
that the rack cannot be swivelled around the pillar see fig 8 .
Fig 06-07
Fig 08
5. Locate and fit the crank handle (9) to the shaft, ensuring that
you tighten the grub screw onto the machined flat on the shaft,
this will keep the worm gear in position, see figs 9-10.
Fig 09
6. Check that the bracket can be driven up and down the
column and can swivel around the pillar. Locate the lift and shift
clamping handle (10) and screw it into the threaded hole to the
rear of the mounting bracket arm (2) and tighten, see fig 11.
Check it has ‘pinched’ up on the column and the bracket is
immobile; both in its up and down travel and swivel movement.
Fig 11
7. Slot the drill table (2e or 2f) into the machined hole to the
front of the mounting arm (2b and 2c) and screw a lift and shift
clamping handle (10) into to the threaded hole beneath the
table and tighten, see figs 12-13. Check it has ‘pinched’ up on
the drill table spigot and the drill table is immobile.
Radial Standing Drill Only
Fig 12-13-14
Rise and fall rack
cup chamfer
Machined flat
9
10
2f
2e
Summary of Contents for 105105
