11
Setting Up
Sanding Configurations
CONNECT THE SANDER TO THE
MAINS SUPPLY
Remove all tools away for the machine, Switch on, wait
until the machine has reached full speed and check that
the belt is tracking properly. If not, switch off, wait for
the machine to come to a complete stop, disconnect
the sander and go to page 9 for “Tracking the Belt”.
Reconnect, switch on and check again. If everything is
fine, switch off and wait until the machine has come to a
complete stop.
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY
Dust Extraction
The dust extraction mouldings (h) have a 45mm outlets, (See figs 29-30) Insert a jubilee clip over the hose and insert it
over the outlet and clamp in place. Alternately, if you have a vacuum cleaner with the same diameter holes insert it over
the outlet as before, it should be a snug fit.
Disc Sanding
Belt Sanding
Angle Sanding
Fig 29.
Fig 30.
h
h
