8
Assembly
Setting Up
C
C
E
Fig 11.
Fig 12.
‘T’ slot
Slide the mitre fence (E) into the table ‘T’ slot
Locate the mitre fence (E) and slot it into the table (C) ‘T’ slot (See figs 11-12).
Table Adjustment
NOTE: BEFORE USING YOUR BELT
AND DISC SANDER YOU NEED TO
CHECK THAT THE TABLES ARE
PERPENDICULAR BY USING A 90°
SQUARE.
Place a 90° square on the sanding disc table (C) and check
that the table is perpendicular to the sanding disc. If it
requires adjustment loosen the two lift and shift handles
(H), adjust until correct and re-tighten the two handles
(See figs 13-14). Check that the scale pointer is set to 0°
and adjust if required (See fig 15).
Reposition the square and check the mitre fence (E) is
perpendicular to the disc and adjust if required. Reset the
pointer on the mitre fence to 0° (See fig 16).
H
E
Fig 13.
Fig 15.
Fig 14.
Fig 16.
Scale
Pointer
Pointer
