SET UP AND ADJUSTMENT
24
7. Trim any excess material from the end of the fence rail, see
fig 85.
8. Replace the fence assembly and place against the blade. The
magnifying glass pointer should read ‘Zero’ on the fence rail
scale, see fig 86-87.
Fig 85
Fig 86-87-88
The rip fence extension can be repositioned from the vertical
to a horizontal position for guiding thin pieces through. Loosen
the two butterfly knobs holding the fence extension, remove,
lay the fence extension down in the horizontal position and
remount the fence extension as before, see fig 89-90. Move
the extension down until the end face is centred with the
blade and tighten the two butterfly knobs.
Fig 89-90
‘Zero’ pointer
Rip Fence Extension
Magnifing Class Pointer
set to ‘ZERO’
Summary of Contents for 107712
