09
W H I T E
A X M I N S T E R
W
Assembly...
Rubber Feet Assembly
Step 2
Sanding Belt Assembly
Step 3
Locate the four rubber feet & M8 nuts
(K)
, screw one nut onto the threaded foot. Screw the
foot into one of the four pre-drilled holes in each corner of the casting, repeat for the
remaining feet. Stand the belt & disc sander up-right on a flat surface and adjust the feet
until the sander is level. Tighten the nuts to lock the feet in place. (See figs 7 & 8)
Fig 7
Fig 8
K
Fig 9
With the linisher in up-right position undo the two phillips screws and remove the linisher’s
dust deflector
(a),
place safely aside. (See fig 9) Remove the linishers back guard by
undoing the two phillips screws
(b)
(See fig 10).
a
b
Fig 10
Fig 11
Fig 12
I
Pull the tensioning lever “UP”, locate the sanding belt
(I)
& slide it onto the linisher.
(See fig 11). Re-tension the belt by pushing the tension lever “DOWN” (see fig 12),
