After installation, the device must be tuned to both the helicopter and transmitter, which first includes adaptation of the transmitter to the sys
-
tem, followed by setting up the system to the model. The software includes a setup wizard guiding you swiftly and easily through all the requi-
red steps without missing any. Additionally there is helpful information available for each parameter in the ‘I’ on the top right of every window.
At this point, please install and open the software and start the setup wizard.
Prior to this, do read the following notes!
1. IMPORTANT BEFORE FIRST FLIGHT AND AFTER ANY CHANGES!
EXTENDED CONTROL CHECK INCLUDING A DIRECTION TEST FOR ALL 3 GYRO DIRECTIONS
a) When the model is ready to fly, check the neutral position and direction of all stick functions and servos. If the swashplate shows
an increasing tilt while increasing the head gyro gain, this must be related to inaccurate transmitter neutral trim.
Check in DIAGNOSE page.
b) Check directions of all three sensor axes, as an incorrect direction would definitely result in a crash.
Briefly tilt and turn the model in the directionof all three axis. The swashplate and tail must initially respond with the opposite
action. In the event of this not happening correctly, incorrect programming is the source of the error, either in the direction of the
bars in the DIAGNOSE menu or in the mounting orientation setting.
c) RC range check.
2. DASHBOARD MENU: BACKUP OF ALL SETTINGS IN THE PC
Data backup is optional, since all settings are stored permanently in the device, unless they are overwritten by new
values or are subject to a factory reset.
It does, however, make sense to save settings when carrying out tests with various parameters. If the result is not satisfactory, then it
is easily possible to restore the previous data by loading the backup into the device.
In this case, the bank switching is very helpful too. Define one main parameter set and conduct any testing using the other 2 banks
only, so that it is easy to switch back to the “safe” bank at all times. Whichever bank you use as the “safe” bank is up to your preference.
SETUP / ADJUSTMENT
7
