17
17
1) Connect to Your Stimulator
1
Hold the Remote Control on the same side of your body as
the Stimulator. Press the “Connect” button on the center of
the Remote Control.
2
The stimulation level lights will flash. Flashing lights mean the
Remote Control is trying to connect to the Stimulator. It may
take up to 25 seconds for the Remote Control to connect to
the Stimulator.
3
Watch for the stimulation level lights to stop flashing and the
stimulator battery light to turn on. This means the Remote
Control is communicating with the Stimulator. (If no light is
visible connection has failed. See Troubleshooting.)
Note: The most common issue is not having your Remote Control close
enough to the Stimulator. If your initial connection attempt fails, move
the Remote Control closer to the Stimulator and retry.
Note: Moving the Remote Control while connected to the Stimulator
may result in loss of communication.
Summary of Contents for Model 2301
