4. Product description
WARNING
Do not smoke or handle open flames when refueling.
Remember that it is not allowed to store fuel in spaces not specifically designed
for it. Since there is no ventilated storage space on this boat, possible spare fuel
cans must be stored on deck.
The fuel filter (if available) is located under the helmsman' seat.
The fuel tank is located midpart of the keel. Try to prevent damage to the fuel lines.
The fuel tank valves are located under the helmsman's seat. The EPA fuel system is equipped with an
automatic fuel valve. The components of the tank are under the helmsman´s seat.
The inlet pipe for fuel is located in the port side of the deck.
(1) Fuel filter (if available, depending on the engine selection)
(2) Fuel inlet fitting
(3) Automatic fuel valve
(4) Fuel tank
4.2.8.1. Refueling the boat
If the boat has optional decking material, wet down the deck with water before refueling. This ensures
that any fuel spillage will float on the water and not penetrate the decking material.
Water reaching the engine's injection system can cause rapid corrosion damage to the precision
components in the injection pump components. For this reason, it is vital to check the extra fuel filter
regularly for water. Every so often, drain a small quantity of fuel into a suitable container (avoid fuel
spillage) and check that there is no condensation water. If there is water in the filter, continue to drain
until only clean fuel appears.
The fuel system on the engine is sensitive to air bubbles in the fuel. Always fill the tanks well before they
are completely empty. If the system has been run dry, it must be bled before the engine can be started
again. See the engine manufacturer's instruction manual before bleeding the fuel system.
Axopar 22 Spyder
Document ID: 22S202103EN
Owner's Manual
© 2021 Axopar Boats
Page 27
-
-
Summary of Contents for 22 SPYDER
Page 1: ...OWNER S MANUAL AXOPAR 22 SPYDER ...
Page 59: ......
