EN
11
5.6 Loss of signal and connection with the base
a) Loss of connection between the headset the and base is indicated
with sound.
b) Lack of signal is indicated by the same sound as in case of signal loss
(looped every 5 seconds)
5.7 Hearing protection adjustment
(see Figure 12)
With your well-being in mind, Axtel Prime X3 headphones are equipped
with three levels of Acoustic Protection: 85 decibels (highest level of
protection), 87 decibels and 105 decibels.
To change the
Acoustic Protection
level, place the switched-on
headset on the base and
then press both +/- volume control buttons
simultaneously for approximately 3 seconds
. A diode indicates the
current level of acoustic protection
•
Single
diode flash – 85
decibels
•
Double
diode flash – 87
decibels
•
Triple
diode flash – 105
decibels
5.8 Resetting the headset
(see Figure 13)
To reset the headset, press the RESET button located in a small opening
on the headset next to the docking port
(
point 1
in Figure 13).
We recommend using a thin, pointed object for this purpose.
The headset will turn off after the above action.
Then remove the object which you used to press the RESET button
from the hole, and turn the headset on again by pressing the MFB
button (
point 2
in Figure 13).
Pressing both
+/- buttons
simultaneously for
1 second changes
the Acoustic
Protection level.
MFB
– (Multifunction button)
indicates the current level of
Acoustic Protection
Figure12
1
2
Figure 13
