Remove the rubber cap
.
Remove the nozzle cover with pliers while
the gun is still hot.
WARNING:
Always wear heat resistant gloves
since both the nozzle cover and the nozzle is hot.
NOTE: Put the spray gun on a piece of masking
paper while repositioning the nozzle. Hot adhesive
can drip from the gun while the nozzle/nozzle
cover is dismantled.
Summary of Contents for TEC 7300
